Şanzıman Zinciri Mekanik ekipmanlarda ekipmanların çalışma performansını ve servis ömrünü etkileyen çok kritik bir iletim yapısıdır. Bu nedenle olağan zamanlarda zincirin bakımını yapmak çok gereklidir.
- sprocket should be installed on the shaft without skew or swing. The end faces of the two sprockets in the same assembly should be in the same plane. When the center distance of the sprocket is less than 0.5 meters, the allowable deviation is 1 mm; when the center distance of the sprocket is more than 0.5 meters, the allowable deviation is 2 mm. However, it is not allowed to rub the side of the sprocket tooth. If the two-wheel knitting is too large, it will easily cause chain disconnection and accelerated wear. When replacing the sprocket, check and adjust the offset.
- tightness of the chain should be appropriate. Too tight increases power consumption and bearings are easy to wear; too loose chain is easy to jump and fall off. The tightness of the chain is: lifted or pressed down from the middle of the chain, the center distance between the two sprockets is about 2%-3%.
- chain is too long or stretched after use, and it is difficult to adjust. You can remove the chain-link depending on the situation, but it must be an even number. The chain link should pass through the back of the chain , the lock piece should be inserted outside, and the opening of the lock piece should face the opposite direction of rotation.
- Dişli ciddi şekilde aşındıktan sonra, iyi bir kavrama sağlamak için yeni dişli ve yeni zincir aynı anda değiştirilmelidir. Sadece yeni bir zinciri veya yeni dişliyi değiştirmek tek başına mümkün değildir. Aksi takdirde, birbirine geçmenin zayıf olmasına neden olacak ve yeni zincirin veya yeni dişlinin aşınmasını hızlandıracaktır. Dişlinin diş yüzeyi belirli bir dereceye kadar aşındığında, zamanla ters çevrilerek kullanılmalıdır (ayarlanabilir yüzeyli kullanılan dişliden bahsediyoruz). Kullanım süresini uzatmak için.
- old chain cannot be mixed with part of the new chain, otherwise, it is easy to have an impact on the chain and break the chain.